基于ST公司的BlueNRG-2蓝牙低功耗无线系统级芯片(SoC)开发方案
原标题:ST BlueNRG-2蓝牙低功耗无线系统级芯片(SoC)开发方案
ST公司的BlueNRG-2是和蓝牙指标兼容的低功耗(BLE)单模式系统级芯片(SoC),基于高性能超低功耗ARM Cortex M0核,包括了256KB可编程闪存存储器,24KB SRAM,以及SPI,UART,I2C标准通信接口外设.同时还具有线性稳压器和DC/DC降压转换器,多功能计时器,看门狗,RTC和DMA控制器.工作电压1.7V-3.6V,工作温度-40℃ 到105℃,主要用在手表,健身和运动设备,消费类医疗设备,遥控,家庭和工业自动化,手机和PC外设和照明,以及安全/接近应用.本文介绍了BlueNRG-2主要特性和架构图,总线架构图以及评估板STEVAL-IDB008V1主要特性,框图,电路图,材料清单和PCB设计文件.
The BlueNRG-2 is a very low power Bluetooth low energy (BLE) single-mode system-on-chip, compliant with Bluetooth specification. The BlueNRG-2 extends the features of award-winning BlueNRG network processor, enabling the usage of the embedded Cortex M0 for running the user application code.
The BlueNRG-2 includes 256 KB of programming Flash memory, 24 KB of static RAM memory with retention (two 12 KB banks) and SPI, UART, I²C standard communication interface peripherals. It also features multifunction timers, watchdog, RTC and DMA controller.
An ADC is available for interfacing with analog sensors, and for reading the measurement of the integrated battery monitor. A digital filter is available for processing a PDM stream.
The BlueNRG-2 offers the same excellent RF performance of the BlueNRG radio, and the integrated high efficiency DC/DC converter keeps the same ultra-low power characteristics, but the BlueNRG-2 improves the BlueNRG sleep mode current consumption allowing a further increase in the battery lifetime of the applications.
The BlueNRG-2 integrates:
ARM Cortex-M0 core
Interrupts management
256 KB Flash memory
24 KB of RAM with two retention options (12 KB or 24 KB)
Power management
Clocks
Bluetooth low energy radio
Random number generator (RNG) (reserved for Bluetooth low energy protocol stack, but user applications can read it)
Public Key Cryptography (PKA) (reserved for Bluetooth low energy protocol stack)
Peripherals:
SPI interface
UART interface
I²C bus interface
GPIO
Multifunction timer
DMA controller
Watchdog
RTC
ADC with battery indicator and temperature sensor
PDM stream processor
BlueNRG-2主要特性:
Bluetooth low energy single mode system-on-chip compliant with Bluetooth 4.2specification:
master, slave and multiplesimultaneous roles
LE Data Packet Length Extension
Operating supply voltage: from 1.7 to 3.6 V
Integrated linear regulator and DC-DC step-down converter
Operating temperature range: -40 ℃ to 105℃
High performance, ultra-low power Cortex-M0 32-bit based architecture core
Programmable 256 KB Flash
24 KB RAM with retention (two 12 KBbanks)
1 x UART interface
1 x SPI interface
2 x I²C interface
14, 15 or 26 GPIOs
2 x multifunction timer
10-bit ADC
Watchdog & RTC
DMA controller
PDM stream processor
16 or 32 MHz crystal oscillator
32 kHz crystal oscillator
32 kHz ring oscillator
Battery voltage monitor and temperaturesensor
Up to +8 dBm available output power (atantenna connector)
Excellent RF link budget (up to 96 dB)
Accurate RSSI to allow power control
8.3 mA TX current (@ -2 dBm, 3.0 V)
Down to 1 μA current consumption withactive BLE stack (sleep mode)
Suitable for building applications compliantwith the following radio frequencyregulations: ETSI EN 300 328, EN 300 440,FCC CFR47 Part 15, ARIB STD-T66
Pre-programmed bootloader via UART
QFN32, QFN48 and WCSP34 packageoptions
BlueNRG-2应用:
Watches
Fitness, wellness and sports
Consumer medical
Security/proximity
Remote control
Home and industrial automation
Assisted living
Mobile phone peripherals
Lighting
PC peripherals
评估板STEVAL-IDB008V1
The STEVAL-IDB008V1 is an evaluation platform based on the BlueNRG-2, low power Bluetooth® smart system on chip with 256 KB Flash , 24 KB RAM, compliant with the Bluetooth SMART specification, supporting master, slave and simultaneous master-and-slave roles and Bluetooth low energy extended data length feature.
The STEVAL-IDB008V1 also provides a set of hardware resources for implementing a wide range of application scenarios: sensor data (accelerometer, pressure and temperature sensor), remote control (buttons and LEDs) and debug message management though USB virtual COM. Three power options are available (USB only, battery only, external power supply + USB) for high application development and testing flexibility.
评估板STEVAL-IDB008V1主要特性:
Bluetooth® SMART board based on the BlueNRG-2 Bluetooth low energy system on chip
Associated BlueNRG-2 development kit SW package including firmware and documentation
Up to +8 dBm available output power (at antenna connector)
Excellent receiver sensitivity (-88 dBm)
Very low power consumption: 7.7 mA RX and 8.2 mA TX at +0 dBm
Bluetooth® SMART specification compliant, supports master, slave, simultaneous master-and-slave roles and Bluetooth low energy extended data length feature
Integrated balun which integrates a matching network and harmonics filter
SMA connector for antenna or measuring equipment
3 user LEDs
2 user buttons
3D digital accelerometer and 3D digital gyroscope
MEMS pressure sensor with embedded temperature sensor
RoHS compliant
图.评估板STEVAL-IDB008V1外形图
评估板STEVAL-IDB008V1材料清单:
责任编辑:HanFeng
【免责声明】
1、本文内容、数据、图表等来源于网络引用或其他公开资料,版权归属原作者、原发表出处。若版权所有方对本文的引用持有异议,请联系拍明芯城(marketing@iczoom.com),本方将及时处理。
2、本文的引用仅供读者交流学习使用,不涉及商业目的。
3、本文内容仅代表作者观点,拍明芯城不对内容的准确性、可靠性或完整性提供明示或暗示的保证。读者阅读本文后做出的决定或行为,是基于自主意愿和独立判断做出的,请读者明确相关结果。
4、如需转载本方拥有版权的文章,请联系拍明芯城(marketing@iczoom.com)注明“转载原因”。未经允许私自转载拍明芯城将保留追究其法律责任的权利。
拍明芯城拥有对此声明的最终解释权。