NXP MFRC522 13.56 MHz RFID无接触读写方案
原标题:NXP MFRC522 13.56 MHz RFID无接触读写方案
nxp公司的MFRC522 是13.56 MHz 无接触通信的高度集成的读/写IC,支持ISO/IEC 14443 A/MIFARE模式,两个方向的传输速率高达848 kBd. MFRC522工作电压2.5V到3.3V,提供SPI,串行UART和I2C总线接口,具有CRC协处理器和可编程I/O引脚,内部有自测试.本文介绍MFRC522主要特性, 简化和详细方框图, 读/写模式, 总线接口图以及典型应用方框图.
MFRC522: Contactless reader IC
The MFRC522 is a highly integrated reader/writer IC for contactless communication at 13.56 MHz. The MFRC522 reader supports ISO/IEC 14443 A/MIFARE mode.The MFRC522’s internal transmitter is able to drive a reader/writer antenna designed to communicate with ISO/IEC 14443 A/MIFARE cards and transponders without additional active circuitry. The receiver module provides a robust and efficient implementation for demodulating and decoding signals from ISO/IEC 14443 A/MIFARE compatible cards and transponders. The digital module manages the complete ISO/IEC 14443 A framing and error detection (parity and CRC) functionality.
The MFRC522 supports MF1xxS20, MF1xxS70 and MF1xxS50 products. The MFRC522 supports contactless communication and uses MIFARE higher transfer speeds up to 848 kBd in both directions.
The following host interfaces are provided:
• Serial Peripheral Interface (SPI)
• Serial UART (similar to RS232 with voltage levels dependant on pin voltage supply)
• I2C-bus interface
MFRC522主要特性:
Highly integrated analog circuitry to demodulate and decode responses
Buffered output drivers for connecting an antenna with the minimum number of external components
Supports ISO/IEC 14443 A/MIFARE
Typical operating distance in Read/Write mode up to 50 mm depending on the antenna size and tuning
Supports MF1xxS20, MF1xxS70 and MF1xxS50 encryption in Read/Write mode
Supports ISO/IEC 14443 A higher transfer speed communication up to 848 kBd
Supports MFIN/MFOUT
Additional internal power supply to the smart card IC connected via MFIN/MFOUT
Supported host interfaces
SPI up to 10 Mbit/s
I2C-bus interface up to 400 kBd in Fast mode, up to 3400 kBd in High-speed mode
RS232 Serial UART up to 1228.8 kBd, with voltage levels dependant on pin voltage supply
FIFO buffer handles 64 byte send and receive
Flexible interrupt modes
Hard reset with low power function
Power-down by software mode
Programmable timer
Internal oscillator for connection to 27.12 MHz quartz crystal
2.5 V to 3.3 V power supply
CRC coprocessor
Programmable I/O pins
Internal self-test
图1.MFRC522简化方框图
图2.MFRC522详细方框图
图3.MFRC522读/写模式
图4.MFRC522 I2C总线接口图
图5.MFIN和MFOUT信号路经图
图6.MFRC522典型应用方框图
责任编辑:David
【免责声明】
1、本文内容、数据、图表等来源于网络引用或其他公开资料,版权归属原作者、原发表出处。若版权所有方对本文的引用持有异议,请联系拍明芯城(marketing@iczoom.com),本方将及时处理。
2、本文的引用仅供读者交流学习使用,不涉及商业目的。
3、本文内容仅代表作者观点,拍明芯城不对内容的准确性、可靠性或完整性提供明示或暗示的保证。读者阅读本文后做出的决定或行为,是基于自主意愿和独立判断做出的,请读者明确相关结果。
4、如需转载本方拥有版权的文章,请联系拍明芯城(marketing@iczoom.com)注明“转载原因”。未经允许私自转载拍明芯城将保留追究其法律责任的权利。
拍明芯城拥有对此声明的最终解释权。