基于On Semi公司的NCV8876汽车启动-停止控制解决方案
原标题:On Semi NCV8876汽车启动-停止控制解决方案
On Semi公司的NCV8876是异步升压DC/DC转换控制器,升压模式工作在6.8V,在汽车启动-停止控制电池电压上提供最低输出电压,输出电压精度2%,输入电压2V-40V.本文介绍了NCV8876主要特性和典型应用框图, 评估板NCV887601主要特性,电路图,材料清单和PCB元件布局图.
The NCV8876 is a Non-Synchronous Boost controller designed to supply a minimum output voltage during Start-Stop vehicle operation battery voltage sags. The controller drives an external N-channel MOSFET. The device uses peak current mode control with internal slope compensation. The IC incorporates an internal regulator that supplies charge to the gate driver.Protection features include, cycle-by-cycle current limiting, protection and thermal shutdown.Additional features include low quiescent current sleep mode operation. The NCV8876 is enabled when the supply voltage drops below 7.3 V, with boost operation initiated when the supply voltage is below 6.8 V.
NCV8876主要特性:
•Automatic Enable Below 7.3 V (Factory Programmable)
•Boost Mode Operation at 6.8 V
•2% Output Accuracy Over Temperature Range
•Peak Current Mode Control with Internal Slope Compensation
•Externally Adjustable frequency Operation
•Wide Input Voltage Range of 2 V to 40 V, 45 V Load Dump
•Low Quiescent Current in Sleep Mode (<11 A Typical)
•Cycle−by−Cycle Current Limit Protection
•Hiccup−Mode Overcurrent Protection (OCP)
•Thermal Shutdown (TSD)
•This is a Pb−Free Device
NCV8876典型应用:
•Applications Requiring Regulated Voltage through Cranking and Start−Stop Operation
图1. NCV8876典型应用框图
评估板NCV887601
NCV887601BSTGEVB: Automotive High-Frequency Boost Controller Evaluation Board
This NCV887601 evaluation board provides a convenient way to evaluate a high frequency boost controller designed to supply a minimum output voltage during Start-Stop vehicle battery voltage sags. The unit is in low Iq sleep-mode under normal battery operating condition and will wake-up when the monitored voltage drops below 7.3 V and begin regulating once 6.8 V is reached. Switching frequency is set to 440 kHz with a user selectable ROSC resistor. The evaluation board is rated 6.8 V / 3.6 A at a 2.6 V input voltage. Operation below 2.6 V is possible if output current is reduced.
评估板NCV887601主要特性:
• Automatic enable below 7.3 V
• Boost Operation at 6.8 V
• 440 kHz Switching Frequency
• Input Undervoltage Lockout
• Wide Input Voltage of 2.6 V to 45 V
• Low Quiescent Current in Sleep Mode (<11uA Typical)
• Cycle-by-Cycle Current Limit Protection
• Status Monitoring
• Automotive Grade
图2. NCV887601启动-停止评估板外形图
NCV887601升压6.8V/3.6A评估板材料清单:
责任编辑:HanFeng
【免责声明】
1、本文内容、数据、图表等来源于网络引用或其他公开资料,版权归属原作者、原发表出处。若版权所有方对本文的引用持有异议,请联系拍明芯城(marketing@iczoom.com),本方将及时处理。
2、本文的引用仅供读者交流学习使用,不涉及商业目的。
3、本文内容仅代表作者观点,拍明芯城不对内容的准确性、可靠性或完整性提供明示或暗示的保证。读者阅读本文后做出的决定或行为,是基于自主意愿和独立判断做出的,请读者明确相关结果。
4、如需转载本方拥有版权的文章,请联系拍明芯城(marketing@iczoom.com)注明“转载原因”。未经允许私自转载拍明芯城将保留追究其法律责任的权利。
拍明芯城拥有对此声明的最终解释权。