0 卖盘信息
BOM询价
您现在的位置: 首页 > 技术方案 >工业控制 > 基于TI公司的LMX2571低功耗宽带RF频率合成器解决方案

基于TI公司的LMX2571低功耗宽带RF频率合成器解决方案

来源: 中电网
2019-02-26
类别:工业控制
eye 130
文章创建人 拍明

原标题:TI LMX2571低功耗宽带RF频率合成器解决方案

  TI公司的LMX2571是低功耗宽带PLLatinum™ RF频率合成器,集成了Delta-Sigma分数N PLL,多核压控振荡器(VCO),可编输出分压器和两个输出缓冲器.VCO核频率高达5.376MHz,连续输出频率10 MHz 到1344 MHz,主要用在双向无线电,陆基雷达,点对点微波通信,SDR,矢量信号分析仪,无线通信测试仪,无线中继器,TETRA基站等.本文介绍了LMX2571主要特性,框图,几种典型应用电路,以及LMX2571EVM评估板(EVM)主要特性,电路图,材料清单和PCB设计图.

  The LMX2571 is a low-power, high-performance, wideband PLLatinum™ RF synthesizer that integrates a delta-sigma fractional N PLL, multiple core voltage-controlled oscillator (VCO), programmable output dividers and two output buffers. The VCO cores work up to 5.376 GHz resulting in continuous output frequency range of 10 MHz to 1344 MHz.

  This synthesizer can also be used with an external VCO. To that end, a dedicated 5-V charge pump and an output divider are available for this configuration.A unique programmable multiplier is also incorporated to help improve spurs, allowing the system to use every channel even if it falls on an integer boundary.

  The output has an integrated SPDT switch that can be used as a transmit/receive switch in FDD radio application. Both outputs can also be turned on to provide 2 outputs at the same time.

  The LMX2571 supports direct digital FSK modulation through programming or pins. Discrete level FSK, pulse shaping FSK, and analog FM modulation are supported.

  A new FastLock technique can be used allowing the user to step from one frequency to the next in less then 1.5 ms even when an external VCO is used with a narrow band loop filter.

  LMX2571主要特性:

  Any Frequency from 10 MHz to 1344 MHz

  Low Phase Noise and Spurs

  –123 dBc/Hz at 12.5 kHz Offset @ 480 MHz

  –145 dBc/Hz at 1 MHz Offset @ 480 MHz

  Normalized PLL Noise Floor of –231 dBc/Hz

  Spurious Better Than –75 dBc/Hz

  New FastLock to Reduce Lock Time

  A Novel Technique to Remove Integer Boundary Spurs

  Integrated 5-V Charge Pump and Output Dividerfor External VCO Operation

  2-, 4- and 8-level or Arbitrary Level Direct Digital FSK Modulation

  One TX/RX Output or Two Fanout Outputs

  Crystal, XO or Differential Reference Clock Input

  Low Current Consumption

  39-mA Typical Synthesizer Mode (Int. VCO)

  9-mA Typical PLL Mode (Ext. VCO)

  24-Bit Fractional-N Delta Sigma Modulator

  LMX2571主要应用:

  2-Way Radio

  Land Defense: Radar

  Military: Radar/Electronic Warfare

  Point-to-Point Microwave Backhaul

  Software Defined Radio (SDR)

  Vector Signal Analyzer

  Wireless Communications Tester

  Endoscope

  Military and Avionics Imaging

  Oscilloscope

  Signal & Waveform Generator

  TETRA Base Station

  Vector Signal Generator

  Wireless Repeater

  图1.LMX2571框图

  图2.LMX2571应用框图

  图3.LMX2571合成器双工模式应用电路图

  图4.LMX2571PLL双工模式应用电路图

  图5.LMX2571合成器/PLL双工模式应用电路图

  LMX2571EVM评估板(EVM)

  The Texas Instruments LMX2571EVM evaluation module (EVM) helps designers evaluate the operationand performance of the LMX2571 Wideband Frequency Synthesizer. The EVM contains one FrequencySynthesizer.

  The LMX2571EVM is an evaluation board for the LMX2571 which is a frequency synthesizer with low noise, high performance integrated VCO. The VCO core is a low noise 5GHz VCO, after the output channel divider, the divided down frequencies are 10MHz to 1400MHz.

  The internal VCO is bypassable, allowing the use of external VCO. A separated 5V charge pump is dedicated for external VCO, eliminating the need for an op-amp to support 5V VCO. Output of the external VCO can also route through another output channel divider.

  LMX2571EVM can be programmed via (1) SPI programming, (2) I2S programming and (3) PIN mode. PIN mode supports up to 8-level FSK modulation. The board can be powered with a 5V external supply.

  LMX2571EVM评估板(EVM)主要特性:

  External VCO option

  Output channel divider supports 10MHz to 1400MHz operations

  Direct digital FSK modulation

  One TX/RX output or two fanout outputs

  Crystal, XO or differential reference clock input

  图6.LMX2571EVM评估板(EVM)外形图

  LMX2571EVM评估板(EVM)材料清单:




责任编辑:HanFeng

【免责声明】

1、本文内容、数据、图表等来源于网络引用或其他公开资料,版权归属原作者、原发表出处。若版权所有方对本文的引用持有异议,请联系拍明芯城(marketing@iczoom.com),本方将及时处理。

2、本文的引用仅供读者交流学习使用,不涉及商业目的。

3、本文内容仅代表作者观点,拍明芯城不对内容的准确性、可靠性或完整性提供明示或暗示的保证。读者阅读本文后做出的决定或行为,是基于自主意愿和独立判断做出的,请读者明确相关结果。

4、如需转载本方拥有版权的文章,请联系拍明芯城(marketing@iczoom.com)注明“转载原因”。未经允许私自转载拍明芯城将保留追究其法律责任的权利。

拍明芯城拥有对此声明的最终解释权。

相关资讯

方案推荐
基于MC33771主控芯片的新能源锂电池管理系统解决方案

基于MC33771主控芯片的新能源锂电池管理系统解决方案

AMIC110 32位Sitara ARM MCU开发方案

AMIC110 32位Sitara ARM MCU开发方案

基于AMIC110多协议可编程工业通信处理器的32位Sitara ARM MCU开发方案

基于AMIC110多协议可编程工业通信处理器的32位Sitara ARM MCU开发方案

基于展讯SC9820超低成本LTE芯片平台的儿童智能手表解决方案

基于展讯SC9820超低成本LTE芯片平台的儿童智能手表解决方案

基于TI公司的AM437x双照相机参考设计

基于TI公司的AM437x双照相机参考设计

基于MTK6580芯片的W2智能手表解决方案

基于MTK6580芯片的W2智能手表解决方案