0 卖盘信息
BOM询价
您现在的位置: 首页 > 技术方案 >工业控制 > 基于Silabs公司的EFM32ZG222 32位MCU应用开发方案

基于Silabs公司的EFM32ZG222 32位MCU应用开发方案

来源: 中电网
2019-02-21
类别:工业控制
eye 367
文章创建人 拍明

原标题:Silabs EFM32ZG222 32位MCU应用开发方案

  Silabs公司的EFM32HG322F64是基于32位ARM Cortex-M0+核的低功耗微控制器,工作频率高达24MHz,采用创新的低能耗技术,短叫醒时间,以及各种外设,非常适合用在以电池为能源的应用和高性能低功耗的系统.本文介绍了EFM32ZG222主要特性,框图,以及入门套件入门套件EFM32ZG-STK3200主要特性,框图和电路图.

  The EFM32 MCUs are the world’s most energy friendly microcontrollers. With a unique combinationof the powerful 32-bit ARM Cortex-M0+, innovative low energy techniques, short wake-up time fromenergy saving modes, and a wide selection of peripherals, the EFM32ZG microcontroller is well suitedfor any battery operated application as well as other systems requiring high performance and low-energyconsumption. This section gives a short introduction to each of the modules in general terms and alsoshows a summary of the configuration for the EFM32ZG222 devices. For a complete feature set and indepthinformation on the modules, the reader is referred to the EFM32ZG Reference Manual.

  EFM32ZG222主要特性:

  • ARM Cortex-M0+ CPU platform

  • High Performance 32-bit processor @ up to 24 MHz

  • Wake-up Interrupt Controller

  • Flexible Energy Management System

  • 20 nA @ 3 V Shutoff Mode

  • 0.5 μA @ 3 V Stop Mode, including Power-on Reset, Brown-outDetector, RAM and CPU retention

  • 0.9 μA @ 3 V Deep Sleep Mode, including RTC with 32.768 kHzoscillator, Power-on Reset, Brown-out Detector, RAM and CPUretention

  • 48 μA/MHz @ 3 V Sleep Mode

  • 114 μA/MHz @ 3 V Run Mode, with code executed from flash

  • 32/16/8/4 KB Flash

  • 4/4/2/2 KB RAM

  • 37 General Purpose I/O pins

  • Configurable push-pull, open-drain, pull-up/down, input filter,drivestrength

  • Configurable peripheral I/O locations

  • 16 asynchronous external interrupts

  • Output state retention and wake-up from Shutoff Mode

  • 4 Channel DMA Controller

  • 4 Channel Peripheral Reflex System (PRS) for autonomous inter-peripheral signaling

  • Hardware AES with 128-bit keys in 54 cycles

  • Timers/Counters

  • 2× 16-bit Timer/Counter

  • 2×3 Compare/Capture/PWM channels

  • 1× 24-bit Real-Time Counter

  • 1× 16-bit Pulse Counter

  • Watchdog Timer with dedicated RC oscillator @ 50 nA

  • Communication interfaces

  • Universal Synchronous/Asynchronous Receiver/Transmitter

  • UART/SPI/SmartCard (ISO 7816)/IrDA/I2S

  • Triple buffered full/half-duplex operation

  • Low Energy UART

  • Autonomous operation with DMA in Deep SleepMode

  • I2C Interface with SMBus support

  • Address recognition in Stop Mode

  • Ultra low power precision analog peripherals

  • 12-bit 1 Msamples/s Analog to Digital Converter

  • 4 single ended channels/ differential channels

  • On-chip temperature sensor

  • Current Digital to Analog Converter

  • Selectable current range between 0.05 and 64 uA

  • 1× Analog Comparator

  • Capacitive sensing with up to 5 inputs

  • Supply Voltage Comparator

  • Ultra efficient Power-on Reset and Brown-Out Detector

  • 2-pin Serial Wire Debug interface

  • Pre-Programmed UART Bootloader

  • Temperature range -40 to 85 ºC

  • Single power supply 1.98 to 3.8 V

  • TQFP48 package

  EFM32ZG222主要应用:

  • Energy, gas, water and smart metering

  • Health and fitness applications

  • Smart accessories

  • Alarm and security systems

  • Industrial and home automation

  图1。EFM32ZG222框图

  入门套件EFM32ZG-STK3200

  The EFM32ZG-STK3200 is an excellent starting point to get familiar with the EFM32 Zero Geckomicrocontrollers. The kit contains a few buttons and LEDs, some capactive touch pads and a very lowpower Memory LCD-TFT display. In addition to demonstrating the EFM32 Zero Gecko’s capabilities, thekit can also serve as a good starting point for application development.

  Supported by Simplicity Studio, the starter kit contains sensors and peripherals demonstrating some of the MCU’s many capabilities and can serve as a starting point for application development. The EFM32ZG-STK3200 features an on-board SEGGER J-Link debugger and an Advanced Energy Monitoring system, allowing you to program, debug and perform real-time current profiling of your application without using external tools.

  入门套件EFM32ZG-STK3200主要特性:

  EFM32ZG222F32 MCU with 32 KB Flash and 4 KB RAM

  Advanced Energy Monitoring system for precise current tracking

  Integrated SEGGER J-Link USB debugger/emulator with debug out functionality

  20 pin expansion header

  Breakout pads for easy access to I/O pins

  Power sources include USB and CR2032 battery

  2 user buttons, 2 user LEDs

  2 capacitve touch pads

  Ultra low power 128x128 pixel Memory-LCD

  Crystals for LFXO and HFXO: 32.768 kHz and 24.000 MHz

  Supported by Simplicity Studio

  图2。入门套件EFM32ZG-STK3200外形图

  图3。入门套件EFM32ZG-STK3200框图



责任编辑:HanFeng

【免责声明】

1、本文内容、数据、图表等来源于网络引用或其他公开资料,版权归属原作者、原发表出处。若版权所有方对本文的引用持有异议,请联系拍明芯城(marketing@iczoom.com),本方将及时处理。

2、本文的引用仅供读者交流学习使用,不涉及商业目的。

3、本文内容仅代表作者观点,拍明芯城不对内容的准确性、可靠性或完整性提供明示或暗示的保证。读者阅读本文后做出的决定或行为,是基于自主意愿和独立判断做出的,请读者明确相关结果。

4、如需转载本方拥有版权的文章,请联系拍明芯城(marketing@iczoom.com)注明“转载原因”。未经允许私自转载拍明芯城将保留追究其法律责任的权利。

拍明芯城拥有对此声明的最终解释权。

相关资讯